What Does the Inverter Error Mean?
The GE washer Inverter Error indicates a problem with the inverter board or the communication between the inverter and the drive motor.
The inverter board controls the speed and operation of the washer motor. If the inverter cannot properly regulate motor performance or communicate with the control system, the washer may stop operating and display an Inverter Error.
Common Causes of the GE Inverter Error
Several issues can trigger an Inverter Error, including:
- Faulty inverter board
- Damaged drive motor
- Loose wiring connections
- Damaged wire harnesses
- Power surges or voltage fluctuations
- Moisture damage to electronic components
- Main control board communication problems
How To Fix GE Washer Inverter Error
Follow these troubleshooting steps to help diagnose and fix the Inverter Error.
1. Disconnect Power
Unplug the washer from the electrical outlet before beginning any inspection or repair.
2. Perform a Power Reset
Allow the washer to remain unplugged for at least 10 minutes.
Temporary inverter communication issues may clear after a full reset.
3. Inspect Wiring Connections
Check wiring connected to the:
- inverter board
- drive motor
- main control board
Look for:
- loose connectors
- damaged wires
- corrosion
- burnt terminals
4. Check for Moisture Damage
Inspect accessible electronic components for:
- moisture
- corrosion
- water damage
Moisture can interfere with inverter operation and communication.
5. Inspect the Drive Motor
Look for signs of:
- overheating
- unusual noises
- damaged components
- loose mounting hardware
A failing motor can sometimes trigger inverter-related errors.
6. Run a Test Cycle
Reconnect power and start a short wash cycle.
If the error returns, the inverter board or motor may require professional diagnosis or replacement.
How To Reset GE Washer After an Inverter Error
You can often reset the washer using these steps:
- Turn off the washer.
- Unplug the washer from power.
- Wait approximately 10 minutes.
- Plug the washer back in.
- Start a short wash cycle.
Some GE washer models may use slightly different reset procedures.
Frequently Asked Questions
What causes a GE washer Inverter Error?
The most common causes include a faulty inverter board, damaged motor, loose wiring, or communication problems between electronic components.
Can a power surge trigger an Inverter Error?
Yes. Electrical surges and voltage fluctuations can sometimes damage or disrupt inverter operation.
Will unplugging the washer clear the error?
Sometimes. A power reset may temporarily clear the error if it was caused by a communication issue.
Can a bad motor cause an Inverter Error?
Yes. Problems with the drive motor can affect the inverter system and trigger the error.
Is an Inverter Error expensive to repair?
Simple wiring issues may be inexpensive to fix. Replacing an inverter board or drive motor can be more costly depending on the washer model.