Maytag Washer F1E1 Main Control Board Error

What Does the F1E1 Error Mean?

The Maytag washer F1E1 error code indicates a problem with the main electronic control board.

The control board acts as the washer’s central computer, managing functions such as filling, washing, draining, spinning, and monitoring sensors. When the control board detects an internal fault or communication problem, the washer may display the F1E1 error code and stop operating.

Common Causes of the Maytag F1E1 Error

Several issues can trigger the F1E1 error code, including:

  • Faulty main control board
  • Power surges or electrical interruptions
  • Loose wiring connections
  • Damaged wire harnesses
  • Corroded electrical connectors
  • Internal control board failure
  • Communication problems between electronic components

How To Fix Maytag Washer F1E1 Error

Follow these troubleshooting steps to help diagnose and fix the F1E1 error code.

1. Disconnect Power

Unplug the washer from the electrical outlet before beginning any inspection or troubleshooting.

2. Perform a Power Reset

Allow the washer to remain unplugged for at least 5 minutes.

Temporary electronic glitches may sometimes clear after a full power reset.

3. Check the Power Supply

Inspect the electrical outlet and power cord for:

  • loose connections
  • visible damage
  • burn marks
  • signs of overheating

4. Inspect Wiring Connections

If accessible, inspect wiring connected to the control board.

Look for:

  • loose connectors
  • damaged wires
  • corrosion
  • burnt terminals

5. Check for Moisture Damage

Moisture inside the control area can cause electronic problems.

Inspect accessible components for signs of:

  • water damage
  • corrosion
  • condensation

6. Run a Test Cycle

Reconnect power and start a short wash cycle.

If the F1E1 error returns, the main control board may require replacement.

How To Reset Maytag Washer After F1E1 Error

You can often reset the washer using these steps:

  1. Turn off the washer.
  2. Unplug the washer from power.
  3. Wait approximately 5 minutes.
  4. Plug the washer back in.
  5. Start a short wash cycle.

Some Maytag washer models may use slightly different reset procedures.

Frequently Asked Questions

What does F1E1 mean on a Maytag washer?

The F1E1 error code usually indicates a problem with the washer’s main electronic control board.

Can a power surge cause the F1E1 error?

Yes. Power surges and electrical interruptions can sometimes trigger control board errors.

Will unplugging the washer clear the F1E1 error?

Sometimes. A power reset may temporarily clear the error if it was caused by a software or communication issue.

Can bad wiring cause the F1E1 error?

Yes. Loose, damaged, or corroded wiring can interfere with communication and trigger the F1E1 code.

Is the F1E1 error expensive to repair?

Simple wiring or connection issues may be inexpensive to fix. Replacing the main control board can be one of the more costly washer repairs.

Related Maytag Washer Error Codes