Maytag Washer F9E1 Drain Error Code

What Does F9E1 Mean?

The Maytag washer F9E1 error code indicates a drain system problem. The washer is detecting that water is not draining properly or that the drain cycle is taking too long to complete.

In many cases, the washer may stop during the rinse or spin cycle and display the F9E1 code on the control panel.

Common Causes of the Maytag F9E1 Error

Several issues can trigger the F9E1 code, including:

  • Clogged drain hose
  • Blocked drain pump filter
  • Faulty drain pump
  • Kinked or crushed drain hose
  • Drain hose installed incorrectly
  • Wiring or control board issues
  • Excess detergent buildup causing drainage problems

How To Fix Maytag F9E1 Error

Follow these troubleshooting steps to help diagnose and fix the F9E1 error code.

1. Disconnect Power

Unplug the washer from the electrical outlet before beginning any inspection or repair.

2. Inspect the Drain Hose

Check the drain hose for:

  • kinks
  • bends
  • clogs
  • pinched sections

Make sure the hose is not pushed too far into the standpipe drain.

3. Clean the Drain Pump Filter

Many Maytag washers include a drain filter near the bottom front access panel.

Remove and clean the filter thoroughly. Common items found inside include:

  • lint
  • coins
  • hair pins
  • fabric debris

Be prepared for water to spill out during cleaning.

4. Check the Drain Pump

Listen for unusual sounds during the drain cycle.

Possible signs of drain pump failure include:

  • humming without draining
  • grinding noises
  • leaking
  • intermittent draining

5. Run a Drain and Spin Cycle

After cleaning and inspection:

  • reconnect power
  • restart the washer
  • run a drain and spin cycle

If the washer drains correctly, the issue may be resolved.

How To Reset Maytag Washer After F9E1 Error

You can often reset the washer using these steps:

  1. Unplug the washer from power.
  2. Wait approximately 5 minutes.
  3. Plug the washer back in.
  4. Press the Pause/Cancel button twice.
  5. Run a short rinse and spin cycle.

Some Maytag washer models may use slightly different reset procedures.

Frequently Asked Questions

Can I still use my Maytag washer with an F9E1 error?

It is not recommended. Continuing to use the washer without fixing the drainage problem may damage the drain pump or other components.

What is the difference between F21 and F9E1?

Both codes relate to draining problems. F21 usually indicates a long drain condition, while F9E1 often refers to a broader drain system issue.

Can a clogged filter cause F9E1?

Yes. A clogged drain filter is one of the most common causes of the F9E1 error code.

Will unplugging the washer clear the error?

Sometimes. However, if the underlying problem remains, the error code will likely return.

How expensive is it to repair F9E1?

Simple clogs are often inexpensive to fix. Replacing a drain pump or control board may cost more depending on the washer model.

Related Maytag Washer Error Codes