Maytag Washer LOC Control Lock

What Does the LOC Code Mean?

The Maytag washer LOC code indicates that the Control Lock feature has been activated.

This is not actually an error code. Instead, it means the washer’s control panel has been locked to prevent accidental button presses or setting changes during operation.

When Control Lock is enabled, many buttons on the washer may become unresponsive.

Common Causes of the Maytag LOC Code

The LOC code is usually caused by one of the following:

  • Control Lock feature activated accidentally
  • Buttons pressed and held unintentionally
  • Control Lock enabled during a previous cycle
  • Settings saved from earlier use

In most cases, the washer itself is operating normally.

How To Turn Off Maytag Washer LOC Control Lock

Follow these steps to disable the Control Lock feature.

1. Locate the Control Lock Button

Many Maytag washer models have a button labeled:

  • Control Lock
  • End of Cycle Signal
  • Cycle Signal
  • Hold 3 Seconds

The exact button varies by model.

2. Press and Hold the Button

Press and hold the designated button for approximately 3 seconds.

The LOC indicator should disappear from the display once the Control Lock feature is disabled.

3. Restart the Washer

If the LOC code remains:

  • turn the washer off
  • unplug it for several minutes
  • reconnect power
  • try disabling Control Lock again

How To Reset Maytag Washer After LOC Code

You can often reset the washer using these steps:

  1. Turn off the washer.
  2. Unplug the washer from power.
  3. Wait approximately 5 minutes.
  4. Plug the washer back in.
  5. Press and hold the Control Lock button for 3 seconds.

Some Maytag washer models may use slightly different procedures.

Frequently Asked Questions

What does LOC mean on a Maytag washer?

LOC stands for Control Lock. It indicates that the washer’s control panel lock feature is enabled.

Is LOC an actual error code?

No. LOC is a feature indicator rather than a washer malfunction.

Why won’t my Maytag washer buttons work?

If Control Lock is enabled, many control panel buttons may be temporarily disabled.

How do I remove the LOC code from my Maytag washer?

Press and hold the designated Control Lock button for approximately 3 seconds until the indicator disappears.

Can unplugging the washer clear the LOC code?

Sometimes. However, Control Lock settings may remain active after reconnecting power depending on the washer model.

Related Maytag Washer Error Codes